W35.50-1127-09
1 | Lift bellows | 5 | Nuts (upper bracket) | |
2 | Cross member (lower lift bellows) | 6 | Cross member (upper lift bellows) | |
3 | Stop buffer | 7 | Nuts (lower bracket) | |
4 | Bow | 8 | Compressed-air connector |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Topical note | Notes on self-locking nuts and bolts | ||
Notes on compressed air connection systems | |||
| Remove | ||
1 | Secure vehicle with chocks at rear axle to prevent it from rolling away. | ||
2 | Switch on ignition. | ||
3 | Fully lower trailing axle. | ||
4 | Switch off ignition. | ||
5 | Remove compressed air connector (8). | ||
6 | Remove brackets (4). | ||
7 | Remove stop buffers (3). | ||
8 | Remove lift bellows (1) with crossmembers (2, 6). | ||
| Install | ||
9 | Clean contact surface of crossmember (2). | ||
10 | Insert lift bellows (1) with crossmembers (2, 6). | The compressed air connection must point forwards. | |
11 | Install stop buffers (3). | Stop buffer, cross member of lower lift bellows to bracket | |
12 | Install brackets (4). | ||
13 | Attach compressed air connector (8). | ||
14 | Switch on ignition. | ||
15 | Fully raise trailing axle. | ||
16 | Switch off ignition. | ||
17 | Check compressed air connection (8) for leak tightness. | Use commercially available leak detector spray. | |
18 | Remove wheel chocks from rear axle. |