W35.50-1127-09
1 | Lift bellows | 5 | Nuts (upper bracket) | |
2 | Cross member (lower lift bellows) | 6 | Cross member (upper lift bellows) | |
3 | Stop buffer | 7 | Nuts (lower bracket) | |
4 | Bow | 8 | Compressed-air connector |
| Remove | ||
1 | Secure vehicle at rear axle using wheel chocks to prevent it from rolling away. | ||
2 | Switch on ignition | ||
3 | Fully lower trailing axle | ||
4 | Switch off ignition | ||
5 | Unscrew nuts (5) from bracket (4) t be removed and remove bracket (4) from cross member (6) | Do not change the installation positions of the nuts (7). | |
| Install | ||
6 | Fit nuts (7) to bracket (4) | Only if the bracket (4) has been replaced. | |
7.1 | Insert bracket (4) into cross member (6)and install nuts (5) | If the bracket (4) has not been replaced. | |
Do not change the installation positions of the nuts (7). | |||
Nut, top bracket to lift bellows cross member | |||
7.2 | Insert bracket (4) into cross member (6) and lightly fasten nuts (5) | If the bracket (4) has been replaced. | |
8 | Adjust bracket (4) | Only if the bracket (4) has been replaced. | |
Distance "B" between bracket and axle at bottom (trailing axle completely lowered) | |||
Thread protrusion "A" at top of bracket | |||
Nut, top bracket to lift bellows cross member | |||
9 | Switch on ignition | ||
10 | Fully raise trailing axle | ||
11 | Switch off ignition | ||
12 | Remove wheel chocks from rear axle |