AR27.60-P-0910A | Adjust shift lock | 10.2.11 |
TRANSMISSION 722.60 /610,
722.610 /611 up to 30.11.00,
722.612 /613 /62 (except , 722.626 /628),
722.630 up to 30.11.00,
722.631 /66 /645
P27.60-0231-06
Shown at center shifter console of model 140
111 Screw
117 Bracket
124 Cam plate
125 Locking lever
126 Adjustment screw
Y66/1 Reverse/parking lock valve
Adjust | |||
1 | Move selector lever into neutral position | The selector lever must make contact with the shift gate (arrow). | |
2 | Apply battery voltage of 11 V up to 14 V to the reverse/parking lock valve (Y66/1) | Use the connecting cable from the electrical connection kit. | |
3 | Loosen bolt (111) | ||
4 | Adjust gap (A) between locking lever (125) and disk cam (124) using adjuster screw (126) | The adjusting screw (126) must contact the bracket (117) with no gap | |
5 | Tighten screw (111) | |
Shift lock test values
Number | Designation | Transmission 722.6 | ||
BE27.60-P-1001-01A | Gap dimension "a" between locking lever | mm | 0,2 | |
Figure see | ||||
Tightening torques for floor shift
Number | Designation | Trans-mission 722.6 | |
BA27.60-P-1003-02A | Bolt for bracket to shift lock on bearing bracket upper section | Nm | 3.5 |
201 589 00 99 00
Electrical connection set