Transmission | 722.9 in model 217 with engine 157 |
Transmission | 722.9 in model 217 with engine 276.8 |
Transmission | 722.9 in model 217 with engine 278 |
Transmission | 722.9 in model 217 with engine 279 |
Transmission | 722.9 in model 222 with engine 157 |
Transmission | 722.9 in model 222 with engine 276.8 |
Transmission | 722.9 in model 222 with engine 277, 279 |
Transmission | 722.9 in model 222 with engine 278 |
Transmission | 722.9 in model 222 with engine 642 |
Transmission | 724.2 in model 222 with engine 276 |
Transmission | 725.0 in model 217, 222 with engine 278 |
Transmission | 725.0 in model 222 with engine 276 |
Shown on engine 278 |
3a | Left engine air intake duct |
3b | Right engine air intake duct |
P01.00-3631-06
Shown: radiator package on engine 278 |
1 | Oil cooler |
2 | Fan unit |
6 | Repair bolt |
7 | Washer |
P27.55-2198-06
Shown: right front engine compartment on engine 278 |
1 | Oil cooler |
8 | Retaining clamp |
9 | Oil cooling line |
10 | Oil cooling line |
11 | Coolant hose |
12 | Coolant hose |
P27.55-2199-06
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Warning | Risk of injury. Skin or eye injuries may result when handling hot or glowing objects. | Wear protective gloves, protective clothing and safety glasses, if necessary. | |
Warning | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
Notes on automatic transmission | |||
| Remove/install | ||
1 | Remove left or right engine air intake duct (3a or 3b) | ||
2 | Drain coolant | ||
Installation: Install front and lower center engine compartment lining only after leak test. | |||
3 | Detach oil lines (9, 10) from oil cooler (1) | ||
Record plug | |||
4 | Seal openings in oil cooler (1) using suitable stop plugs | Record plug | |
5 | Remove coolant hoses (11, 12) from oil cooler (1) | ||
6 | Close off connections of coolant hoses at oil cooler (1) with protective covers | Set of protective caps | |
7 | Seal coolant hoses (11, 12) using protective covers | Set of protective caps | |
8 | Push retaining clip (8) in upward direction and remove oil cooler (1) | | |
If retaining clip (8) is damaged | |||
| |||
secure oil cooler (1) at position marked by arrow using repair bolt (6) and washer (7). | |||
9 | Install in the reverse order | ||
10 | Pour in coolant and bleed cooling system | ||
| Check | ||
11 | Check fluid level in automatic transmission and adjust to correct level |
| |
Transmission 725.0 (except 725.017) in model 222 with engine 276 | |||
Transmission 722.96 in model 217, 222 with engine 276.8 | |||
Transmission 722.9 (except 722.96) in model 217, 222 with engine 276.8 | |||
Transmission 724.2 in model 222 with engine 276.9 | |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
12 | Perform engine test run and check oil lines (9, 10) and oil cooler (1) for leak tightness | ||
13 | Install front and center engine compartment paneling |
001 589 00 91 00
Set of protective caps
129 589 00 91 00
Record plug