208 589 00 21 00
Pressing tool
Structure of multidisk clutch, shown on transmission 722.683 |
5 | Input shaft (with external plate carrier K2) |
9 | Piston |
14 | Disk spring |
15 | External plate (1.8 mm) |
16 | Internal plates |
17 | External plates (2.8 mm) |
18 | Externally toothed disk (4.0 mm) |
19 | Retaining ring |
L | Toothed plate play |
D27.51-1136-01
Structure of multidisk clutch, shown on transmission 722.684 |
5 | Input shaft (with external plate carrier K2) |
9 | Piston |
14 | Disk spring |
15 | External plate (1.8 mm) |
16 | Internal plates |
17 | External plates (2.8 mm) |
18 | Externally toothed disk (4.0 mm) |
19 | Retaining ring |
L | Toothed plate play |
D27.51-1137-01
Structure of multidisk clutch, shown on transmission 722.685 |
5 | Input shaft (with external plate carrier K2) |
9 | Piston |
14 | Disk spring |
15 | External plate (1.8 mm) |
16 | Internal plates |
17 | External plates (2.8 mm) |
18 | Externally toothed disk (4.0 mm) |
19 | Retaining ring |
L | Toothed plate play |
D27.51-1132-01
1 | Put together externally toothed plates (15, 17, 18) and internally toothed plates (16) in the sequence shown and insert individually. |
A different number of external plates (17) and internal plates (16) are fitted depending on the transmission version. Place new external and internal plates in automatic transmission fluid for 1 h before installation. |
2 | Install retaining ring (19). |
Both ends of the circlip (19) must be seated on a lug of the external plate carrier (arrows). |
D27.51-1135-01
3 | Mount pressure device on externally toothed plate (18). |
4 | Press disk pack together as far as the end stop using pressure device and a workshop press. |
The marking ring (bottom arrow) must still be visible. |
5 | Using a feeler gauge, Check plate play (L) at three points between retaining ring (19) and external plate (18). |
To measure the toothed plate play (L) the retaining ring (19) must abut with the upper contact surface of the groove. If necessary, adjust the toothed plate play (L) by installing a retaining ring (19) of corresponding thickness. |
D27.51-1111-03