D27.19-1151-09
Illustration shows model 906.133 except code XM0 (Model refinement) |
1 | Transmission housing | 5 | Oil filter | 8 | Detent plate | ||
2 | Electrical connector | 6 | Oil pan | 9 | Bolts | ||
3 | O-rings | 7 | Selector valve | Y3/8 | Electric control unit | ||
4 | Oil guide pipe |
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
| Remove | ||
1 | Connect diagnostic system and transfer data from electric controller unit (Y3/8) to diagnostic system | When replacing electric controller unit (Y3/8). | |
| |||
2 | Switch off ignition | ||
3 | Lift/jack up vehicle | ||
4 | Detach heat shield from automatic transmission | ||
5 | Remove oil pan (6) | ||
6 | Remove oil filter_(5) | ||
7 | Clean electrical connector, electrical connector (2) and surrounding area thoroughly | Assembly cleaner | |
8 | Disconnect electrical connector from electrical connector (2) | ||
9 | Unscrew screws/bolts (9) and remove electric controller unit (Y3/8) | | |
10 | Remove oil guide pipe (4) from transmission housing (1) | ||
| Install | ||
11 | Install oil guide pipe (4) in transmission housing (1) | Replace the oil guide pipe (4) and the O-rings. | |
12 | Install electric controller unit (Y3/8) | ||
Topical note | Notes on self-locking nuts and bolts | ||
| |||
Replace O-rings(3). | |||
Screw/bolt, electrohydraulic controller unit to transmission housing | |||
13 | Attach electrical connector to electrical connector (2) | ||
14 | Install oil filter (5) | Replace the oil filter (5) and the O-ring. | |
15 | Install oil pan (6) | ||
After replacing the electric controller unit (Y3/8), first transfer the data to the new electric controller unit (Y3/8). Only then should you fill the automatic transmission with oil and check the oil level. | |||
16 | Attach heat shield to automatic transmission | ||
Bolt, heat shield to transmission housing | |||
17 | Transfer data from diagnostic system to new electric controller unit (Y3/8) | After replacing electric controller unit (Y3/8). | |
| |||
18 | Fill automatic transmission with oil, check oil level and correct |
| |
Transmission 722.9 in model 906Transmission without guide tube for oil dipstick | |||
19 | Perform transmission adaptation using diagnostic system | After repair of automatic transmission. | |
| |||
20 | Check automatic transmission for leak tightness with engine running | ||
21 | Lower vehicle |