1 | Transmission housing |
2 | Bolts |
3 | Screw |
N15/11 | Fully integrated transmission control (VGS) electric controller unit |
D27.19-A000-05
4 | Transmission plug |
4a | Sealing ring |
6 | Contact pins |
7a | Oil guide pipe |
7b | Oil guide pipe |
N15/11 | Fully integrated transmission control (VGS) electric controller unit |
D27.19-A001-03
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of injury to skin and eyes due to handling of transmission oil. Health risk caused by swallowing transmission oil | Wear protective gloves, protective clothing and safety glasses. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Notes on self-locking nuts and bolts | ||
Topical note | Notes on threaded connections fastened using a tightening angle-based tightening process | ||
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
Topical note | Information on preventing damage to electronic components due to electrostatic discharge | ||
Notes on automatic transmission | |||
| Remove/install | ||
1 | Remove oil pan from automatic transmission. | ||
Installation: Replace oil pan of automatic transmission. | |||
2 | Release and disconnect electrical connector from transmission connector(4). | Installation: Clean transmission connection (4) and electrical connector on fully integrated transmission control (VGS) electric controller unit (N15/11). | |
3 | Remove screw (3). | Screw/bolt, auxiliary oil pump to transmission housing | |
4 | Remove screws (2) and remove fully integrated transmission control electric controller unit (VGS) (N15/11). | | |
Installation: | |||
Installation: Insert plain couplers (7a, 7b) into fully integrated transmission control (VGS) electric controller unit (N15/11). | |||
Screw/bolt, electrohydraulic controller unit to transmission housing | |||
5 | Clean plain couplers(7a,7b), sealing ring(4a) and the area surrounding them. | Assembly cleaner | |
| Check | ||
6 | Check plain couplers (7a, 7b) for damage. | If the plain couplers (7a, 7b) are damaged. | |
| |||
Replace plain couplers (7a, 7b). | |||
7 | Install in the reverse order. | ||
Concluding tasks | |||
8 | Connect vehicle diagnosis system and read out fault memory. | ||
| |||
9 | Perform transmission adaptation with vehicle diagnosis system. | ||
|