AR26.60-P-0635AK | Removing, installing and adjusting shift and selector cables | 24.8.09 |
TRANSMISSION 711, 716 in MODELS 169.0 /3, 245.2
P26.60-2244-06
Shown on vehicle with transmission 716
1 Selector cable
2 Shift cable
3 Screw
4 Floor-mounted shift
P26.60-2262-11
Shown on vehicle with transmission 716
1 Selector cable
2 Shift cable
5 Fuse
6 Fuse
8 Adjuster
9 Adjuster
1 Selector cable
2 Shift cable
7 Boot
P26.60-2259-03
| Remove/install | ||
Danger! | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between columns of vehicle lift and position four support plates at vehicle lift support points specified by vehicle manufacturer. | |
1 | Secure vehicle on the lifting platform | ||
2 | Move transmission into neutral position | ||
3 | Remove front seats | ||
4 | Remove center console | On vehicles with code (570) front arm support/armrest | |
On vehicles without front armrest | |||
Installation: Before installing the center console: | |||
Adjust selector cable (1) and shift cable (2). | |||
5 | Remove front left floor covering | ||
6 | Remove front right floor covering | ||
7 | Remove sound deadening mat | ||
8 | Detach latch hook from shift cable (2) and unscrew shift cable (2) upwards from the center shifter console (4) | ||
9 | Detach latch hook from selector cable (1) and unscrew selector cable (1) upwards out of the center shifter console (4) | ||
10 | Push locking devices (5, 6) of the adjusters (8, 9) backwards, lock in this position by twisting clockwise | Mark installation position to make adjustment of the shift cable (2) and selector cable (1) easier. | |
11 | Pull shift cable (2) out of adjusting device (8) and selector cable (1) out of adjusting device (9). | Observe correct installation position. | |
12 | Lower engine with front axle carrier | Engine 640 | |
Engine 266.920/940/960 | |||
Engine 266.980 | |||
13 | Unclip boot (7) of shift cable (2) and of selector cable (1) from firewall using a suitable tool | Unclip boot (7) carefully as in the event of damage to the boot (7) the shift cable (2) and selector cable have to be replaced (1). | |
Installation: The marking on the boot (7) must point upwards. The boot (7) must not be installed twisted or tilted, as with a repeat removal there is a risk of damage to the boot (7) and thus the shift cable (2) and selector cable (1) would have to be replaced. | |||
14 | Detach shift cable (2) and selector cable (1) on transmission | ||
Long-life grease | |||
| Attachment of shift cable changed | ||
15 | Guide shift cable (2) and selector cable (1) together out of the firewall and remove | Installation: Assistant required. Check catch tabs for correct seat from the interior. | |
16 | Unhook adjusters (8, 9) on the center shifter console (4) and remove | ||
17 | Install in the reverse order |
Repair materials
Number | Designation | Order number |
BR00.45-Z-1001-06A | Long-life grease | A 000 989 63 51 11 |