P91.10-3262-09
Shown on left front seat (1)
model 169.0
1 Front seat
2 Covers
3 Covers
4 Screw
X55/3 Driver seat connector block
X55/4 Front passenger seat connector block
5 Screw
6 Screw
7 Screw
| Remove/install | ||
Danger! | Risk of injury caused by performing testing or repair work on airbag or emergency tensioning retractor units. | Store airbag units with deployment side facing up; do not expose to temperatures greater than 100 °C. When working on these units, disconnect the power supply. | |
| Notes on performing repair, body work and welding on vehicles with airbags or emergency tensioning retractor units | ||
| Information on preventing damage to electronic components due to electrostatic discharge | ||
| Assessment of airbag and emergency tensioning retractor units in accident vehicles | ||
| Legal requirements on handling and storing airbags and emergency tensioning retractor units | ||
1 | Set backrest on front seat (1) upright | ||
2 | Move front seat (1) to rear and up | ||
3 | Remove fire extinguisher | When removing the driver seat on vehicles with code (682) Fire extinguisher. | |
4 | Remove covers (2) to the front and remove the bolts (4, 5) concealed below | Installation: Replace bolts (4, 5). | |
Installation: First tighten bolt (4), then bolt (5). | |||
| |||
5 | Adjust front seat (1) to front | ||
6 | Remove covers (3) and remove the bolts (6, 7) concealed below | Installation: Replace bolts (6, 7). | |
Installation: First tighten bolt (6), then bolt (7). | |||
| |||
7 | Place front seat (1) in center position | ||
8 | Switch off the ignition and remove the transmitter key from the EIS control unit | ||
9 | Detach driver seat connector block (X55/3) or front passenger seat connector block (X55/4) | ||
10 | Lift front seat (1) out of vehicle | Aid of helper required. | |
11 | Install in the reverse order |
Front seats