Shift mechanism
Number | Designation | Trans-mission 711.603 | Trans-mission 711.612 | Trans-mission 711.613 | ||
BA26.60-N-1004-01A | Screw plug, lower part of the shift lever | Nm | 60 | 60 | 60 | |
D26.60-0004-01
1 Insert guide sleeve (11) and compression spring (12).
2 Screw in and tighten screw plug (13).
D26.50-0003-02
3.1 Measure length "A" of opposite sleeve of backup light switch actuation (11).
(only transmission 711.603 up to end no. 054494, transmission 711.612 /613 up to end no. 054661, )
3.2 Measure length "A" front section of thrust piece of backup light switch actuation (11).
(only transmission 711.603 as of end no. 054495, transmission 711.612 /613 as of end no. 054662)
D26.60-0005-01
4 Move the gearshift lever on the installed left thrust piece until it abuts.
5 Over the installation bore of the backup light switch measure the dimension "B" from the lay-on edge of the thrust piece to the gearshift lever.
6 Determine thickness of the shim.
(length "A" - dimension "B") + 0.1 mm play = thickness of required shim.
Example: (44.9 mm - 43.2 mm) + 0.1 mm = 1.8 mm
Shims are available in 0.1 mm graduation in thicknesses of 0.8 to 2.7 mm.
D26.60-0004-01
7 Remove screw plug (13).
8 Remove guide sleeve (11) and compression spring (12).