Shown on transmission 711.685 |
1 | Front section of transmission housing |
2 | Drive shaft |
3 | Locking plates |
4 | Bolts |
5 | Oil guide |
6 | Countershaft |
7 | Inner bearing race |
8 | Bearing |
9 | Deep-groove ball bearing |
10 | Retaining ring |
D26.40-1174-06
| Remove | ||
Topical note | Notes on self-locking nuts and bolts | ||
1 | Remove transmission | ||
2 | Attach transmission to assembly stand | ||
3 | Remove the central clutch release bearing | ||
4 | Remove front section of transmission housing (1) | ||
Refer to Disassemble/assemble transmission housing. | |||
| Disassemble | ||
5 | Remove lock washers (3) | ||
6 | Remove oil conduit (5) | ||
7 | Press out drive shaft (2) | ||
8 | Detach circlip (10) and press off grooved ball bearing (9) | ||
9 | Remove radial shaft sealing ring of axle shaft (2) | ||
10 | Press out bearing (8) | Drift | |
11 | Remove inner bearing race on output side (7) from countershaft (6) | The inner race of bearing (8) is divided into two halves. The drive side half has been removed with the front section of the transmission housing (1). | |
Puller | |||
Extraction tool | |||
| Clean | ||
12 | Clean seats and bearing seats | Use clean, lint-free rags. | |
| Assemble | ||
13 | Press output side inner bearing race (7) on countershaft (6) | ||
The drive side inner bearing race is installed when assembling the transmission housing front section (1). | |||
Drift | |||
14 | Press grooved ball bearing (9) onto drive shaft (2) and install removed circlip (10) | The chamfer on the outer bearing race must point toward the gear wheel. | |
15 | Check and adjust play between grooved ball bearing (9) and circlip (10) | ||
Replace retaining ring (10). | |||
Axial play between drive shaft bearing and retaining ring | |||
16 | Press in drive shaft (2) as far as the end stop in the front section of the transmission housing (1) | Drift | |
17 | Press in bearing (8) as far as the end stop | The chamfer on the outer bearing race must point up (toward output side). | |
Drift | |||
18 | Install oil conduit (5) | ||
19 | Install lock washers (3) | Replace screws/bolts (4). | |
Screw/bolt, locking plate for countershaft bearing, main shaft bearing or drive shaft bearing to transmission housing | |||
20 | Install new radial shaft sealing ring of drive shaft (2) | ||
| Install | ||
21 | Install front section of transmission housing (1) | ||
Refer to Disassemble/assemble transmission housing. | |||
22 | Install central clutch release bearing | ||
23 | Detach transmission from assembly stand | ||
24 | Install transmission |
716 589 00 15 00
Drift
716 589 02 15 00
Drift
001 589 50 33 00
Puller
711 589 02 33 00
Extraction tool
711 589 15 15 00
Drift