1 | Receptor hydraulic cylinder (slave) |
2 | Identification clamp |
3 | Bleeder |
4 | Bleeder plug |
5 | Pipe connection |
6 | Fastening screws |
B25.20-0004-06
| Remove/install | ||
1 | Turn off the master switch | ||
Warning | Risk of injury caused by pinching and crushing when opening and closing engine hood | No one should be within the swivel range of the engine hood as it is being opened or closed. Always open engine hood all the way to the end position until this engages in the front locks. | |
2 | Open and place the engine hood in vertical position |
| |
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
3 | Tilt the cabin | Tilt cab to repair position, tilt back | |
4 | Open the front cover | Vehicles 682 and 693. | |
Caution | Risk of poisoning from swallowing brake fluid. Risk of injury from skin and eye contact with brake fluid | Only pour brake fluid into suitable and appropriately marked containers. Wear protective clothing and eye protection when handling brake fluid. | |
5 | Remove the fluid from the hydraulic reservoir by suction | ||
6 | Connect the bleeding equipment and remove the brake fluid through the bleeder (3) of the hydraulic slave cylinder (1) | The brake fluid that has been circulating through the system must not be re-utilized but be discarded ecologically. | |
Utilize appropriate equipment for testing and bleeding of brakes, clutch and steering. | |||
7 | Disconnect the metal piping at the connection (5) of the hydraulic slave cylinder (1) | The metal piping must not be folded nor forced along its lay-out. | |
8 | Remove the four bolts (6) and lift-off the clutch housing, the hydraulic slave cylinder (1) | .Bolts attaching the clutch slave cylinder | |
9 | Remove the identification clamp (2) | On the clamp are engraved the part number, nominal cylinder diameter and the piston stroke. | |
The clamp must always go together with the cylinder, even after the change of the repair kit. | |||
Installation: Secure the identification clamp on the cylinder. | |||
10 | Replace the hydraulic slave cylinder repair kit | ||
11 | Install in reverse order | ||
12 | Fill with new specified brake fluid | Brake fluid, DB supply specification 7760.30 (DOT 4) | |
13 | Bleed the hydraulic clutch actuation system |
| |
14 | Check the hydraulic system for tightness |