S20.10-2003-11
1 Coolant pipe
2 Bolt
3 Coolant thermostat
4 Seal
| Removing, installing | ||
1 | Disconnect ground cable at the battery | Installation: encode radio | |
2 | Remove coolant pipe (1) | ||
3.1 | Remove oil return flow line at crankcase | Engine 601.970 | |
Oil may flow out. | |||
Installation: replace gasket and seal | |||
| |||
Danger! | Risk of injury to skin and eyes from scalding from hot coolant which splashes out. Risk of poisoning from swallowing coolant. | Do not open the cooling system unless the coolant temperature is below 90 °C. Open cap slowly and allow the pressure to release. Do not pour coolant into containers for drinks. Wear protective gloves, protective clothes, and eye protection. | |
4 | Unscrew bolt (2) from the cover of the coolant thermostat (3) at the coolant pump housing | | |
| |||
5 | Remove cover of coolant thermostat | Installation: replace seal (4). | |
6 | Install in the reverse order | ||
| Inspecting | ||
7 | Inspect cooling system for leaks |
Turbocharger
Number | Designation | Engine 601.970 | |
BA09.40-N-1001-01A | Nut of turbocharger to exhaust manifold | Nm | 21 |
BA09.40-N-1002-01A | Lubricating oil line to union of turbocharger | Nm | 22 |
BA09.40-N-1003-01A | Lubrication oil line to crankcase | Nm | 30 |
BA09.40-N-1004-01A | Oil return flow line to turbocharger | Nm | 9 |
BA09.40-N-1005-01A | Oil return flow line to crankcase | Nm | 9 |
BA09.40-N-1006-01A | Stud bolts in turbocharger | Nm | 11 |
Coolant pump, coolant thermostat
Code | Name | Engine 601.942 601.970 | |
BA20.10-N-1004-01B | Coolant thermostat cover in the coolant pump box | Nm | 10 |
Torx bit set
000 589 01 10 00