AR18.40-W-5115J | Remove/install oil pressure sensor | 23.11.10 |
ENGINES 900.9 in MODELS 375.1, 970, 972, 975, 976
ENGINES 902.9 in MODEL 375.3, 950.5 /6, 952.5 /6, 953.6, 954.5
ENGINES 902.9 in MODEL 957 except CODE (MS8) Natural gas engine
ENGINES 902.9 in MODELS 375.1, 970, 972, 974, 975, 976
ENGINES 924.9 in MODELS 958.0, 970, 972, 974, 975, 976
ENGINES 925.9 in MODELS 970, 972, 974
ENGINES 926.9## ## as of 301562 in MODEL 950.5 /6, 952.5 /6, 953.6, 954.5, 957, 958.2
ENGINES 926.9 in MODEL 958.0
W18.40-1015-05
Shown on engine 926.9
1 Charge air pipe
2 Oil filter cover
3 Air intake hose
4 Electrical connectors
B11 Engine oil temperature sensor
B12 Oil pressure sensor
| Remove/install | ||
1 | Switch off ignition | ||
Danger! | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within tilting range of cab as it is being tilted. Always tilt cab all the way to end position and secure with safety strut. | |
2 | Tilt cab | Installation: Only tilt cab back after leak test has been conducted. | |
| Notes on tilting the cab | ||
3 | Remove soundproofing on frame above on the right | ||
4.1 | Remove air intake hose (3) | MODELS 375, 950, 952, 953, 954, 958, 970, 972, 974, 975, 976 | |
4.2 | Remove air intake pipe | Model 957 | |
5 | Unscrew oil filter cap (2) from oil filter housing | The engine oil flows back into oil pan when the oil filter cover (2) is unscrewed. | |
Installation: Replace O-ring for oil filter cover (2) and check oil filter element for damage and soiling; replace oil filter element if necessary. | |||
| |||
6 | Disconnect electrical connector (4) on engine oil temperature sensor (B11) and on oil pressure sensor (B12) | ||
7 | Remove oil pressure sensor (B12) | Collect engine oil that flows out. | |
Installation: Replace sealing ring. | |||
| |||
8 | Install in the reverse order | ||
9 | Check engine oil level at display; correct if necessary | Observe engine oil grade set in maintenance system or Specifications for Operating Fluids. | |
| Notes on engine oil | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
10 | Start engine and allow to run in idle for 10 s until the oil pressure has built up, then run the engine at varying speeds | ||
11 | Turn off engine and check area of oil pressure sensor (B12) for leaks | Visual inspection. |
Oil filter
Number | Designation | Engines | Engine | |
BA18.20-N-1003-01B | Oil filter cover on oil filter housing | Nm | 25 | 25 |
Oil level sensor, oil pressure sensor