AR18.40-W-5111CA | Remove, install oil level sensor | 31.7.07 |
ENGINE 457.9## ## as of 051235 in MODEL 374, 375, 940, 942, 943, 944, 958
W18.40-1026-12
1 Engine wiring harness
2 Oil pan
B14 Oil level sensor
| Remove/install | ||
1 | Switch off ignition | ||
2 | Remove soundproofings on frame at bottom left | Installation: Only install soundproofing after leaktightness check. | |
3 | Disconnect connector for electrical engine wiring harness (1) on oil level sensor (B14) | ||
4 | Remove oil level sensor (B14) on oil pan (2) | Installation: Replace oil level sensor (B14). | |
| |||
5 | Install in the reverse order | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the engine as it is running | Secure vehicle to prevent it from moving by itself. | |
6 | Start engine and allow to run in idle for 10 seconds until oil pressure has built up, then allow engine to run at alternating rpms | ||
7 | Stop engine and check oil level sensor (B14) on the oil pan (2) for leaks | Visual inspection. | |
8 | Check engine oil level using oil dipstick or on display, correct if necessary | Inspect engine oil level after waiting at least 5 min. after switching off engine. Observe engine oil grade set in maintenance system or Specifications for Operating Fluids. | |
| Notes on engine oil |
Oil level/oil pressure sensor