1 | Protective coverings |
2 | Electrical line |
3 | Electrical wiring harness |
4 | Bolts |
5 | Starter |
6 | Shield |
S15.30-4527-06
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
| Remove/install | ||
1 | Remove ground line of battery. | ||
2 | Raise vehicle. | ||
Topical note | Special instructions for lifting and supporting vehicle | ||
3.1 | Remove rear and center lower engine compartment lining. | Model 470, 471 with engine 699 | |
3.2 | Remove center underguard. | Model 470, 471 with engine 699 | |
4 | Remove automatic engine start/stop relay from transmission. | Model 470 with engine 699 | |
5 | Lift protective covers (1) and push back onto electric lines (2). | ||
6 | Remove electrical lines (2). | Nut, electrical line to starter | |
7 | Remove electrical wiring harness (3) from bracket. | Installation: Replace retaining clip. | |
8 | Remove screws (4). | Bolt, starter to crankcase | |
9 | Remove starter (5) downwards. | ||
10 | Remove shield (6). | If installed. | |
| Check | ||
11 | Check ring gear at flywheel or at drive plate for damage and wear. | To do this turn engine at the center bolt of the crankshaft in direction of engine rotation. | |
If ring gear at flywheel or at drive plate is damaged or worn, | |||
| |||
replace flywheel or drive plate. | |||
Remove/install a flywheel | |||
Remove/install drive plate | |||
12 | Check starter drive pinion for damage and wear. | If starter drive pinion is damaged or worn, | |
| |||
replace starter (5). | |||
13 | Install in the reverse order. |