S03.30-4524-09
1 | Drive plate | 4 | Ring gear | 7 | Hole | ||
2 | Retaining lock | 5 | Bolts | 8 | Crankshaft | ||
3 | Screw | 6 | Hole | 9 | Guide bearing |
Danger | Risk of death caused by vehicle slipping or toppling off of the lifting platform. | Align vehicle between vehicle lift columns and position the four support plates at the vehicle lift support points specified by the vehicle manufacturer. | |
Caution | Risk of injury caused by scraping or cutting body parts on sharp vehicle parts | Always wear protective gloves when working on or near sharp and non-deburred vehicle parts. | |
Topical note | Special instructions for lifting and supporting vehicle | ||
| Remove/install | ||
1 | Remove automatic transmission | ||
2 | Fix drive plate (1) in place | To do this, attach retaining lock (2) as shown and fasten with a suitable screw (3). | |
Retaining lock | |||
3 | Remove drive plate (1) | ||
Topical note | Notes on self-locking nuts and bolts | ||
| |||
| |||
To do this, remove screws (5) counterclockwise in succession. | |||
Installation: Bring bore (6) in the drive plate (1) and bore (7) in the crankshaft (8) to the cover. | |||
Bolt, drive plate to crankshaft | |||
| Check | ||
4 | Check ring gear (4) of the drive plate (1) for damage | Depending on findings | |
| |||
Install new drive plate (1). | |||
5 | Check starter drive pinion for damage | Depending on findings | |
| |||
Replace starter. | |||
6 | Check guide bearing (9) of the crankshaft (8) | Depending on findings | |
| |||
replace guide bearing (9) of the crankshaft (8) with a suitable internal extractor. | |||
7 | Check cap with radial shaft sealing ring for leak tightness | Depending on findings | |
| |||
replace cap with radial shaft sealing ring. | |||
8 | Install in the reverse order |
699 589 00 40 00
Retaining lock