N13.30-2005-01
1 Vacuum line
2 Intake line
3 Hexagon bolts
N13.30-2006-01
N13.30-2007-01
4 Cylinder head
N13.30-2008-01
| Remove/install | ||
1 | Remove vacuum line (1) | Installation: Start engine and check engine for leaks | |
2 | Remove intake duct and hose (2) or pressure line | ||
3 | Loosen hexagon head bolts (3) | | |
4 | Remove cylinder head (4) together with seal | Installation: Clean sealing surfaces then place cylinder head with a new seal on the cylinder liner. | |
| Checking | ||
| With the cylinder head in place loosen the cylinder liner from the cylinder crankcase.In this case, clean the sealing surface and seal using sealant | ||
5 | Pre-tension cylinder liner in a crosswise pattern using 2 hexagon head bolts | ||
6 | Measure piston projection without the seal in place | ||
| |||
| |||
7 | Install in the reverse order |
Test and adjustment values for pistons
Number | Designation | Engine | |
BE03.10-N-1002-02H | Piston projection in top dead center without cylinder head gasket | mm | 0.04 to 0.40 |
Compressor (compressed air system)
Number | Designation | Engine 447, 489 | |
BA13.30-N-1005-01F | Bolt, air compressor to cylinder crankcase | Nm | 35 |
343 589 00 40 00
Dial indicator holder
Dial indicator
001 589 53 21 00
Repair materials
Number | Designation | Order number |
BR00.45-Z-1029-01A | Curil T sealant | - |