5 | Heat shield |
6 | Bolts |
S09.40-4567-11
S09.40-4566-09
1 | Oil pressure line | 2 | Banjo bolt | 3 | Banjo bolt |
Caution | Risk of injury to skin and eyes due to handling of engine oil. Risk of poisoning caused by swallowing engine oil | Wear protective gloves, protective clothing and safety glasses. | |
Topical note | Notes on avoiding damage through contamination and foreign objects | ||
| Remove/install | ||
1 | Remove oxygen sensor upstream of catalytic converter |
| |
2 | Remove heat shield (5) | To do so, remove the screw/bolts (6). | |
Screw/bolt, heat shield to exhaust manifold | |||
3 | Remove banjo bolt (2) | Banjo bolt, turbocharger oil line to turbocharger | |
4 | Remove front right wheel | ||
5 | Remove right fender liner | ||
6 | Remove oil pressure line (1) upwards | To do this, remove banjo bolt (3). | |
Installation: Check seals. | |||
Banjo bolt, exhaust gas turbocharger oil line to crankcase | |||
Depending on findings | |||
| |||
Replace seals. | |||
7 | Install in the reverse order | ||
| Check | ||
8 | Check oil level with oil dipstick | ||
| Low SPAsh multigrade service engine oils (specification 229.31) | ||
| Low SPAsh multigrade service engine oils (specification 228.51) | ||
Depending on findings | |||
| |||
Correct oil level. | |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
9 | Check for leak tightness with engine running | Visual inspection only. |