P07.04-2316-08
Shown on models 211.056 /256
G3/3 O2 Left O2 sensor upstream of TWC
G3/3x1 O2 Connector for left O2 sensor upstream of TWC
G3/4 O2 Right O2 sensor upstream of TWC
G3/4x1 O2 Connector for right O2 sensor upstream of TWC
G3/5 O2 Left O2 sensor downstream of TWC
G3/5x1 O2 Connector for left O2 sensor downstream of TWC
G3/6 O2 Right O2 sensor downstream of TWC
G3/6x1 O2 Connector for right O2 sensor downstream of TWC
P07.04-2378-06
Shown on models 211.087 /287
G3/3 O2 Left O2 sensor upstream of TWC
G3/3x1 O2 Connector for left O2 sensor upstream of TWC
G3/4 O2 Right O2 sensor upstream of TWC
G3/4x1 O2 Connector for right O2 sensor upstream of TWC
G3/5 O2 Left O2 sensor downstream of TWC
G3/5x1 O2 Connector for lft O2 sensor downstream of TWC
G3/6 O2 Right O2 sensor downstream of TWC
G3/6x1 O2 Connector for right O2 sensor downstream of TWC
| Remove/install | ||
Danger! | Risk of injury to skin and eyes caused by handling hot or glowing objects. | Wear safety gloves, protective clothing and safety glasses, if necessary. | |
| Notes on avoiding damage to electronic components due to electrostatic discharge | ||
1 | Turn key in ignition switch to position "0". | ||
2 | Remove rear section of lower engine compartment paneling | Installation: Install engine compartment paneling only after the engine test run. | |
Model 211 | |||
Model 219 | |||
3 | Unclip electrical connector and electrical feed line for corresponding O2 sensor out of retaining clamps on transmission | ||
4 | Disconnect electrical connector for corresponding O2 sensor | ||
5 | Unscrew corresponding O2 sensor out of the catalytic converter completely | Installation: Coat the thread with heat-resistant lubricant. | |
| |||
| |||
Paste | |||
6 | Install in the reverse order | ||
7 | Read out fault memory | STAR DIAGNOSIS diagnosis system | |
| Connect STAR DIAGNOSIS and read out fault memory | ||
Danger! | Risk of accident caused by vehicle starting off by itself when engine is running. Risk of injury caused by contusions and burns during starting procedure or when working near the running engine | Secure vehicle to prevent it from moving by itself. | |
8 | Conduct engine test run and check exhaust system for leaks |
O2 sensor
Number | Designation | Engine | Engine | |
BA14.00-P-1002-01A | O2 sensor to catalytic converter | Nm | 50 | 50 |
000 589 71 03 00
Box wrench bit
Repair materials
Number | Designation | Order number |
BR00.45-Z-1005-06A | Paste, hot lubrication 1 kg, DB supply specification 6879.20 | A 000 989 76 51 |