W03.30-1155-08
1 | Screw/bolts | 4 | Screw/bolts | 7 | Drift | ||
2 | Cover | 5 | Belt pulley/vibration damper | ||||
3 | Belt pulley on fan | 6 | Slinger |
Danger ! | Risk of injury caused by pinching or crushing when working on springs or spring bodies that are under tension | Use only approved tensioning devices; additionally screen off hazardous area if necessary. Check special tools for damage and proper operation (visual inspection). Wear protective gloves. | |
| Notes on self-locking nuts and bolts | ||
| Remove/install | ||
1 | Remove fan | ||
2 | Detension poly-V belt for fan and remove the fan poly-V belt clamping device from the tensioner pulley | ||
3 | Detension poly-V belt for basic belt drive and remove from the alternator belt pulley and the guide pulley | ||
4 | Attach turning device to timing case | ||
Bolt, turning device to timing case | |||
Bolt, inspection hole cap to timing case | |||
Turning device | |||
5 | Block flywheel using turning device | ||
6 | Detach screw/bolts (1) and remove cover (2) | ||
7 | Detach fan belt pulley (3) | Bolt, belt pulley of the fan drive to vibration damper | |
8 | Remove one screw/bolt (4) | Bolt, vibration damper to crankshaft | |
9 | Screw in drift (7) | Drift | |
10 | Remove remaining screw/bolts (4) | Bolt, vibration damper to crankshaft | |
11 | Remove belt pulley/vibration damper (5) | ||
12 | Check belt pulley/vibration damper (5) and all belt pulleys, tensioner pulleys and guide pulleys for driven assembly parts for damage and concentricity | In case of damage or rough running. | |
| |||
Replace assembly parts. | |||
13 | Remove slinger (6) | Installation: Observe installation position. The slinger (6) must be installed with the flat side towards belt pulley/vibration damper (5). | |
14 | Install in the reverse order |
403 589 02 63 00
Drift
904 589 04 63 00
Turning device