Check and correct headlamp adjustment

AP82.10-T-8260A

Check and correct headlamp adjustment

29.10.98



Check

1

Drive vehicle to level surface

 The vehicle must be in ready-to-drive condition.

- Curb weight

- Fuel tank full or appropriate additional weight

- Driver or additional weight of 75 kg

- Pressure of 6.5 bar in compressed-air system.

On vehicles with air suspension, set chassis to "drive position".

Tire inflation pressure must be correct.

AP40.15-T-4060A

2

Align headlamp beam setting equipment to vehicle and check equipment setting according to data on vehicle model plate, adjust if necessary



 Precisely observe operating instructions for headlamp adjustment tester.

*WE58.40-Z-1006-19A



If information is not provided on the model plate, perform test and adjustment according to the guidelines of the German licensing regulations (StVZO).

 Danger!

Risk of accident from vehicle starting off by itself when engine running. Risk of injury suffered in the form of bruises or burns to the hands when reaching in while the engine cranks or runs

Secure vehicle to prevent it from moving off by itself.
Wear closed and close-fitting work clothes.
Do not grasp hot or rotating parts.

AS00.00-Z-0005-01A

3

Start engine, switch on low beam

4

Check setting of low beam and correct if necessary at the adjusting screws (1)

 When setting the height the
light-dark boundary must have the same coverage as the horizontal separation line (4) of the device.
When carrying out the lateral setting, the line (5) must begin below central mark (6) on horizontal broken line (4).

5

Check the setting of the high beam
(main headlamp)

 The center of the light beam must shine on the central mark (6). If this is not the case, check the position of the lamp bulb.

High beam cannot be separately adjusted.

6

Check fog lamp setting

 The light-dark limit must run vertically at the level of the broken line (4).

Fog lamp cannot be separately adjusted.

WE58.40-Z-1006-19A

Headlamp adjustment testing unit