Check and correct the adjustment of the headlamps

AP82.10-P-8260J

15.01.2017

Model

213, 238

Check and correct the adjustment of the headlamps

Halogen headlamp, shown on model 213

E1	Left front lamp unit
E1e1	Left high beam
E1e2	Left low beam

P82.10-8057-01

Static LED headlamp, shown on model 213

E1	Left front lamp unit
E1e1	Left high beam
E1e2	Left low beam

P82.10-8056-01

Dynamic LED headlamp, shown on model 213

E1	Left front lamp unit
E1e2	Left low beam
E1e24	Left front adaptive high beam

P82.10-8055-01

Shown on model 213

01	Headlamp aimer
E1	Left front lamp unit

P82.10-8083-12

 Warning	Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running.	Secure vehicle to prevent it from starting off by itself. Wear buttoned-up and snug-fitting work clothes. Do not touch hot or rotating parts.	AS00.00-Z-0005-01A
	General information on checking/correcting headlamp adjustment		AH82.10-P-1000-01A
	Check
1	Check low beam setting; adjust if necessary	Halogen headlamp ECE version	AP82.10-P-8263O
		Halogen headlamp SAE version	AP82.10-P-8263NA
		Static LED headlamps, ECE version	AP82.10-P-8263KA
		Static LED headlamps, SAE version	AP82.10-P-8263CA
		Dynamic LED headlamps, ECE version	AP82.10-P-8263MA
		Dynamic LED headlamps, SAE version	AP82.10-P-8263LA
		 Before the low beams are checked and adjusted, all operation steps listed in the linked description must be performed carefully. Otherwise it cannot be guaranteed that the headlamps concerned are correctly set, which can then jeopardize the road safety of the vehicle.
2	Switch on high beam	On vehicle with active high beams assistant
		
		Have a second person actuate the headlamp flasher in order to activate the high beams.
3	Check setting of high beam		AP82.10-P-8260-02I
		 The high beams are adjusted when the corresponding low beam headlamp is adjusted; the high beams cannot be adjusted separately. The headlamp adjuster (01) must be positioned in front of the left high beam (E1e1) or left front adaptive high beam (E1e24). Carry out the same procedure for the right side.
		If the high beam setting is not OK.
		
		Rectify the problem subject to a separate repair order.
4	Reset switch positions to input condition

เอกสารที่อ้างถึง