1 | Threaded cap |
2 | Sealing ring |
3 | Filter element |
4 | Dirt collecting tank |
5 | Filter housing |
N07.57-0225-01
Replace | |||
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Warning | Risk of injury caused by body parts being pinched or crushed as cab is tilted | Ensure that no one is within the tilting range of the cab as it is being tilted. Always tilt the cab all the way to the end position and secure it with the safety strut. | |
Topical note | Notes on tilting the cab | ||
1 | Tilt cab | ||
| |||
2 | Open cap on fuel tank, relieve overpressure | ||
3 | Unscrew threaded cap (1) of fuel filter using socket (size 36) | Remove the screw cap (1) with the filter element (3) only after the fuel has drained out of the filter housing (5). | |
4 | Remove threaded cap (1) with filter element (3) and unclip by pressing filter element (3) at sides | ||
5 | Pull dirt collecting container (4) out of filter housing (5) at the shackles | Ensure that any deposited dirt does not enter the filter housing (5). Do not under any circumstances wipe the filter housing (5). | |
6 | Clean threaded cap (1) and dirt collecting tank (4) | ||
7 | Replace seal (2) | Grease sealing ring (2) slightly. | |
8 | Insert new filter element (3) into the screw cap (1) | ||
9 | Insert dirt-collecting vessel (4) into filter housing (5) | Ensure correct installation position. | |
10 | Screw on screw cap (1) with filter element (3) and tighten | Cover on fuel filter housing | |
11 | Start the engine and bleed the fuel system | | |
Run the engine for approx. 1 minute. The fuel system is bled automatically. | |||
12 | Check leak tightness of fuel filter with engine running | ||
13 | Turn off engine | | |
14 | Lower cab | ||
|