P20.30-2555-08
Shown on engine 176.9 in model 222.1 |
1 | Cap | 3 | Engine cover | |
2 | Low-temperature circuit coolant expansion reservoir |
P20.30-2479-09
Shown on engine 177.9 in model 205.0 |
1 | Cap | 2 | Low-temperature circuit coolant expansion reservoir |
P20.30-2536-08
Shown on engine 177.9 in model 213.0 |
1 | Cap | 3 | Engine cover | |
2 | Low-temperature circuit coolant expansion reservoir |
Warning | Risk of injury to skin and eyes suffering scalding from contact with hot coolantspray. Risk of poisoning from swallowing coolant. | Do not open cooling system unless coolant temperature is below 90 °C. Open cap slowly and release the pressure. Do not pour coolant into beverage containers. | |
Topical note | Notes on coolant | ||
| Remove | ||
1 | Remove engine cover (3). | Engine 176 in model 167, 217, 222 | |
Engine 176 in model 167 | |||
| Engine 176 in model 463 | ||
| Engine 177 in model 213 | ||
Engine 177 in model 167, 290 | |||
| Engine 177 in model 463 | ||
2 | Unscrew cap (1) of low-temperature circuit coolant expansion reservoir (2). | ||
| Check | ||
3 | Check coolant level. | The coolant level in a cold engine must reach the marking (arrow) in the low-temperature circuit coolant expansion reservoir (2). When the coolant is warm: approx. 1 cm (0.39 inch) above the marking. | |
If the coolant level is too low, | |||
| |||
Check cooling system for leak tightness and coolant for antifreeze content. | |||
| Coolant specifications | ||
After obtaining special order. | |||
| Install | ||
4 | Seal low-temperature circuit coolant expansion reservoir (2) with cap (1). | ||
5 | Install engine cover (3). | Engine 176 in model 167, 217, 222 | |
Engine 176 in model 167 | |||
| Engine 176 in model 463 | ||
| Engine 177 in model 213 | ||
Engine 177 in model 167, 290 | |||
| Engine 177 in model 463 |