Test and adjustment values, gap dimensions at hoods, doors and covers
Number | Designation | Model | |||
BE60.00-P-1001-01A | Size of gap | Engine hood to fender | Dimension "A" | mm | 4.5 (1) |
Engine hood to headlamp | Dimension "R" | mm | - | ||
Engine hood to radiator grille | Dimension "O" | mm | - | ||
Radiator grill to headlamp | Dimension "N" | mm | - | ||
Fig., see | |||||
BE60.00-P-1002-01A | Size of gap | Front door to A-pillar | Dimension "B" | mm | 6.5 (0.5) |
Front door to fender | Dimension "H" | mm | 5.0 (0.5) | ||
Front door to rear door | Dimension "I" | mm | - | ||
Front door to roof | Dimension "C" | mm | 6.5 (0.5) | ||
Rear door to top of side section | Dimension "D" | mm | 5.0 (0.5) | ||
Rear door to bottom of side section | Dimension "J" | mm | 5.0 (0.5) | ||
Fender to A-pillar | Dimension "Q" | mm | - | ||
Front door to rear fender | Dimension "P" | mm | - | ||
Fig., see | |||||
BE60.00-P-1003-01A | Size of gap | Trunk lid to top of rear fender | Dimension "F" | mm | 4.0 (0.5) |
Trunk lid to bottom of rear fender | Dimension "M" | mm | - | ||
Trunk lid to rear fender | Dimension "F" | mm | 4.0 (0.5) | ||
Trunk lid to taillamp | Dimension "M" | mm | 4.4 (0.5) | ||
Trunk lid to bumper | Dimension "V" | mm | - | ||
Rear fender to taillamp | Dimension "U" | mm | - | ||
Fig., see | |||||
BE60.00-P-1005-01A | Size of gap | Fuel filler flap | Dimension "K" | mm | - |
Dimension "L" | mm | 4.0 (0.5) | |||
Fig., see | - | ||||
BE60.00-P-1012-01A | Size of gap | Center door to front door | Dimension "R" | mm | 5.0 (0.5) |
Center door to rear door | Dimension "S" | mm | 5.0 (0.5) | ||
Center door to roof | Dimension "T" | mm | 6.5 (0.5) | ||
Fig., see | |||||
129 589 03 21 00
Feeler gauge
P60.00-2195-06
Adjust hoods, doors and lids as shown in drawing. The gap should not run wedge-shaped or be too narrow at points. Deviations from parallel gap should be max. 0.5 mm over the entire length. If the inside clearance is too large or too small, the movable body parts must be centered accordingly. The reference measurements apply only for repair work on bodies damaged in accidents.
P60.00-2203-06