Remove/install Telma retarder rotor

AR43.40-D-1600C

Remove/install Telma retarder rotor

12.9.11

 

Remove/install

1

Lift/jack up vehicle

AR00.60-D-1000H

2

Detach corresponding drive shaft of rotor (5) to be set on retarder and fix in place using cable ties

 Mark installation position of front propeller shaft relative to rear drive shaft and retarder. The universal joints of the drive shafts must not be offset to each other, but rather they must be synchronously installed.

 Installation: Install new nuts.



*BA41.10-N-1013-01B



Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

3

Bend up retainer (1)

 Installation: Secure bolt (2) with retainer (1).

4

Remove bolt (2) and retainer (1)

 Installation: Install new retainer (1).



*BA43.40-N-1008-01C

5

Remove disk spring (3) and pressure plate (4)

6

Remove rotor (5) from rotor shaft

 Mark installation position of rotor (5) relative to rotor (5) on opposite side.

 Installation: Observe identification of rotor (5) relative to rotor (5) on opposite side.

7

Install in the reverse order

8

Adjust gap

AR43.40-D-1400C

Number

Designation

Model
906 without code ZG1/ZG2/ZG3/
ZG4

BA41.10-N-1013-01B

Nut, drive shaft to retarder

M101

Stage 1

Nm

15

Stage 2

°

90

Number

Designation

Model
906
with code PB2

BA43.40-N-1008-01C

Bolt, rotor to rotor shaft

M121.5

Nm

50