ar4340d1400c

Adjust gap

Vrsta ar · tema 43.40 · različica 0103 · 2011-09-13

Velja za: MODEL 906 with CODE (PB2) Mastercode retarder VMC

Ni na voljo v jeziku »sl«; prikazano v jeziku Angleščina.

Umestitev

Funkcijska skupina 2 Podvozje › 43 Pnevmatika zavor in dodatne zavore › 43.40 Retarder (električni) — Serija 906

EinPAS 21 zaviranje/podtlačni sistem/pnevmatski sistem › 21.21 retarder › 21.21.30 ohišje/pokrov/gred/retarder — Serija 906

AR43.40-D-1400C

Adjust gap

12.9.11

MODEL 906 with CODE (PB2) Mastercode retarder VMC

Adjust gap

D43.40-0042-09

1 Washer

3 Pole flange

2 Spacer rings

Adjust

1

Measure gap width and note down

AR43.40-D-1500C

2

Remove retarder rotor to be adjusted

AR43.40-D-1600C

3

Set the gap width by removing or adding spacer washers (2)

Washer (1) must be inserted first in direction of pole flange (3).

4

Install retarder rotor

Do not install drive shaft yet.

AR43.40-D-1600C

5

Measure gap width

Repeat procedure if necessary

AR43.40-D-1500C

6

Install drive shafts

Installation: Install new nuts.

*BA41.10-N-1013-01B

Notes on self-locking nuts and bolts

AH00.00-N-0001-01A

Propeller shaft

Number

Designation

Model
906 without code ZG1/ZG2/ZG3/
ZG4

BA41.10-N-1013-01B

Nut, drive shaft to retarder

M101

Stage 1

Nm

15

Stage 2

°

90

Povezani dokumenti