Remove/install lower cover on oil reservoir

AR43.30-G-0068OHA

Remove/install lower cover on oil reservoir

22.01.2017

Model

000.001 with transmission 714.140/143

Transmission with hydrodynamic retarder R115 E (integrated), Voith- 153.000188xx, H67.1500xx

1

Drain plugs

2

Cover

3

Seal

4

Screw

 Danger !

Risk of injury caused by touching hot retarder and by scalding from hot retarderoil. Risk of injury to skin or eyes caused by retarder oil escaping under high pressure

Do not carry out any work unless retarder is switched off. Wear suitable protective clothing and safety glasses when working on the hot retarder.

AS43.30-Z-0001-01A



Remove

1

Have a suitable receptacle for oil ready to hand, remove drain screws (1) and drain off oil completely



AP43.30-G-4302OHA

2

Remove screws (4)

3

Detach cover (2) together with seal (3)



Clean

4

Clean contact surfaces of seal (3)



Install

5

Attach cover (2) together with new seal (3)

 Ensure the correct installation position of the seal (3) relative to the cover (2).

6

Tighten screws (4)

AR43.30-G-0068-01OHA

 Observe the tightening sequence.

 Bolt, oil reservoir cover at bottom to oil reservoir

*BA43.30-N-1027-01H

7

Tighten drain screws (1) and pour in oil



AP43.30-G-4302OHA

 Hydrodynamic retarder

Number

Designation

Model 000.001
with hydrodynamic retarder

BA43.30-N-1027-01H

Bolt, oil reservoir cover at bottom to oil reservoir

Nm

30