1 | Cap |
2 | Sealing ring |
3 | Filter Element |
4 | Housing filter |
G47.20-3114-01
| Clean | ||
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Danger | Risk of explosion caused by fuel igniting, risk of poisoning caused by inhaling and swallowing fuel as well as risk of injury to eyes and skin caused by contactwith fuel. | No fires, sparks, open flames or smoking. Pour fuels into suitable and appropriately marked containers only. | |
Warning | Risk of accident from vehicle starting off by itself when engine running. Risk of injury (bruises and burns) resulting from working on the engine while it is being started or when it is running. | Secure vehicle to prevent it from starting off by itself. Wear closed and snug-fitting work clothes. Do not touch hot or rotating parts. | |
1 | Open the fuel tank cap and close it again | This is necessary to eliminate the excess of pressure from the fuel tank. | |
2 | Clean up externally the fuel pre-filter | ||
3 | Unfasten the cap (1) and remove the filter element (3) from the filter housing (4) | Pay attention to prevent foreign bodies from entering the filter housing (4). Under no circumstances clean the filter housing (4). | |
4 | Clean the cap (1) and the filter element (3) | Replace the filter element (3) if it is too very dirty or damaged. | |
5 | Replace the sealing ring (2) | Grease the sealing ring (2) slightly. | |
6 | Screw and tighten the cap (1) with the filter element (3) | Cover on the fuel pre-filter housing | |
7 | Actuate the engine start-up and bleed the fuel system | Allow the engine to run for approximately 1 minute. The fuel system bleeds automatically. | |
8 | Check the tightness of the pre-filter with the engine running. | ||
9 | Stop the engine |