ap4600p4611rt

Check and correct power steering fluid level

Tip ap · temă 46.00 · versiune 0502 · 2011-05-26

Valabil pentru: MODEL 251 with ENGINE 113, 156, 272, 273, 276, 642

Nu este disponibil în „ro”; afișat în Engleză.

Încadrare

Grupă funcțională 2 Sistem de rulare › 46 Direcţie › 46.00 Generalităţi — Seria 156 · Seria 251

EinPAS 22 Direcţie › 22.15 Servodirecţie › 22.15.5 Servo-direcție completă — Seria 156 · Seria 251

Valabil și pentru motoare/cutii de viteze: 113 ***, 272 ***, 273 ***, 276 ***, 642 ***

AP46.00-P-4611RT

Check and correct power steering fluid level

24.5.11

MODEL 251 with ENGINE 113, 156, 272, 273, 276, 642

Check and correct power steering fluid level

P46.00-2100-04

Shown on ENGINE 113

1 Cap

2 Expansion reservoir

3 Dipstick

A Max marking

B Min marking

Remove/install

Danger!

Risk of injury to skin or eyes caused by hydraulic fluid spraying out under high pressure. Risk of poisoning caused by swallowing hydraulic fluid

Depressurize hydraulic system completely before starting any work on system. Wear protective clothing and safety glasses.

AS00.00-Z-0013-01A

Before opening the hydraulic circuit of the power steering, thoroughly clean the surrounding area of the separation point. Even minute particles of dirt, introduced into the hydraulic components, can result in malfunctions and damage to the power steering.

1

Switch off ignition

2

Remove upper engine cover

Engine 156, 642,
engine 272, 273, 276 with EHPS (electrohydraulic power steering)

In order to avoid damage, put upper engine cover down on padded base.

Installation: install upper engine cover only after completing all maintenance operations.

Engine 156, 272, 273, 276

Remove/install engine cover

Engine 642

AR01.10-P-2405RTB

3

Remove cap (1) of power steering expansion reservoir (2)

Press the cap (1) downwards and turn counterclockwise through 90°.

Clean

4

Wipe oil dipstick (3) with lint-free rag and seal expansion reservoir (2) with cap (1)

Press the cap (1) downwards and turn clockwise through 90°.

Checking

5

Remove cap (1) again and read off oil level on oil dipstick (3), correct oil level if necessary

Observe oil temperature and markings on oil dipstick (3). The oil level must be at the MAX marking (A) corresponding to the oil temperature.

In order to avoid measurement errors, hold oil dipstick (3) upright.

If the fluid level is too low, determine cause and remedy subject to a separate order.

Filling capacity

*BF46.20-P-1001-01D

6

Install in the reverse order

Steering gear

Number

Designation

Model
251 without electrohydraulic P/S (EHPS)

Model
251 with electrohydraulic P/S (EHPS)

BF46.20-P-1001-01D

Power steering

Filling capacity

Liters

1.2

1.5

MB steering gear oil

Sheet

BB00.40-P-0236-03A

BB00.40-P-0236-03A

Documente menționate