P63.10-4775-11
1 Scribe separation point on inner C-pillar (2) (area J).
Transfer separation point from vehicle.
2 Cut inner C-pillar (2) at separation point (area J).
3 Cut out spot welds and laser seam connection at rear shelf reinforcement (4) (areas H, I and K).
Cut out spot weld in area K from inside.
4 Remove rear shelf reinforcement (4).
P63.10-4776-08
5 Grind mating surfaces on inner C-pillar (2) down to bare metal in crosshatched areas.
Grind spot weld flanges down to bare metal on both sides.
6 Coat insides of spot welding flange on inner C-pillar (2) with zinc dust paint.
To prevent adhesion problems, do not coat bonding surfaces with zinc dust paint (area L).
Observe pretreatment of bonding surfaces (area L).
7 Grind mating surfaces on outer C-pillar(1) and reinforcement (3) down to bare metal in crosshatched areas.
Grind spot weld flanges down to bare metal on both sides.
8 Coat insides of spot weld flange on outer C-pillar (1) and reinforcement (3) with zinc dust paint.
P63.10-4779-03