Remove/install flywheel · ar0330l8002va · Mercedes-Benz WIS

AR03.30-L-8002VA

Remove/install flywheel

27.7.01

ENGINE 668.914, 166.961 /991 in MODEL 414.700

P03.30-0287-06

1 Flywheel (engine 166.961)
(two-mass flywheel
engine 166.990, 668.914)

2 Screw

3 Straight pin

 	Remove/install
1	Remove manual transmission		AR26.10-L-0020VA
2	Remove clutch
3	Install retaining lock for crankshaft	 Use retaining lock for severe stresses in starter opening.	AR03.30-P-5000GF
4	Unscrew screws (2)	Installation: Replace bolts (2). If no torquing angle wrench is available, the bolts (2) can be torqued further by the specified angle in a single operation using a wrench and Tommy bar.  In order to eliminate angle errors, do not use a flexi-rod torque wrench for tightening to angle degrees.
		 Engine 166.961/991	*BA03.30-P-1002-01E
		 Engine 668.914	*BA03.30-P-1002-01F
5	Take flywheel (1) off the crankshaft	Installation: Pay attention to straight pin (3). The installation position is fixed by the straight pin (3) and the locating hole (arrow). When replacing the flywheel: 
		Only engine 166.961/991 If the crankshaft position sensor is replaced, carry out reinitialization in control module (N3/5) with STAR Diagnosis in menu "Control module adaptation".
6	Install in the reverse order

 Flywheel, driven plate, vibration damper, starter ring gear

Number	Designation			Engine 166.961/ 991


BA03.30-P-1002-01E	Bolt of flywheel to crankshaft	1st stage	Nm	45
		2nd stage	°	90

 Flywheel, driven plate, vibration damper, starter ring gear

Number	Designation			Engine 668.914


BA03.30-P-1002-01F	Bolt of flywheel to crankshaft	1st stage	Nm	45
		Step 2	°	90

ar0330p5000gf Remover e instalar a trava de bloqueio para a árvore de manivelas/coroa dentada de motor de partida
ar2610l0020va