Notes on securing straightening tool parts in area of rear attachment of front axle carrier to body shell
Only valid for model 205, right-hand drive vehicle
Only valid for model 205, left-hand drive vehicle, HYBRID
Only valid for model 205, left-hand drive vehicle, engine 177, 276, 278, all without 4MATIC
All with installed integral carrier (I-beam) on CELETTE straightening bracket set 7205.5A and 7205.5A-1, and 7205.5A-A or 7205.5A-B.
Factory installation of a reinforcement brace (not shown in picture) between screw/bolt and rear integral carrier attachment on above-mentioned models. The following must be observed in the case of diagnosis and attachment using the straightening tool adapter (1):
Without reinforcement brace: only with part 10 (see assembly diagram)
With reinforcement brace: only with part 51 (see assembly diagram)
In assembly diagram 7205.5AB: incorrectly shown on page 6
1 | Straightening tool adapter |
P60.10-2193-01
P60.10-2194-01
Straightening tool assembly diagram and 7205.5A-A (bottom figure on page 6) | ||||
2 | Reinforcement brace | |||
Straightening tool assembly diagram and 7205.5A-B (bottom figure on page 6) | ||||
P60.10-2195-01
Correct version of figure on page 6: with strut and part 51.
Incorrect version of figure on page 6: without strut and part 51
Changes to straightening tool parts for rear attachment of rear axle subframe to body shell
Valid for all models 205 with installed rear axle subframe on CELETTE straightening bracket set 7205.5A, 7205.5AA.
Owing to the factory screw/bolt version for attaching the rear axle carrier, attachment at the contact surface on the rear elastomer bearing is only possible for the straightening tool adapter (55) without shim (6 mm). The straightening tool adapter (30) must therefore be changed in the first straightening tool set 7205.5A and in the second straightening tool set 7205.5AA. The extension kit 7205.5A2 with new straightening tool adapters (55) is available for this purpose. The affected customers are notified automatically by CELETTE and must be supplied with the parts by CELETTE.
The third straightening tool set 7205.5A-B as well as the supplementary straightening tool sets 7205.5A01 (model 205.1) and 7205.5A02 (mode 205.2) are not affected by this measure.
Please note:
The parts exhibit a height difference of 6 mm.
If the straightening tool adapter (30) is used, the body structure will be deformed during attachment and when the screws/bolts are tightened.
55 | Straightening tool adapter |
P60.10-2196-01
P60.10-2197-01
Illustration shows incorrect part 30 in assembly diagram 7205.5A and 7205.5A-A | ||||
30 | Straightening tool adapter | |||
Illustration with correct part 55, for example in assembly diagram 7205.5A-B | ||||
55 | Straightening tool adapter | |||
P60.10-2198-01