P88.00-2295-08
Shown on vehicle with code (22Y) Headlamp cleaning system
1 CBS front end
2 Bolt
3 Hose (with code (22Y) Headlamp cleaning system)
E6/1 Left turn signal lamp
E6/2 Right turn signal lamp
4 Retaining clamps (with code (22Y) Headlamp cleaning system)
5 Expansion clip
P88.00-2259-08
1 CBS front end
8 Guide
6 Engine hood seal
7 Bolts
P88.00-2260-08
8 Guide
9 Guide
On model 454.034 or on vehicles with code (E58) Front spoiler, Brabus (DFO)
10 BRABUS front spoiler
11 Counterholder
12 Bolt
P88.30-2369-03
| Remove/install | ||
1.1 | Remove left and right side sill protective molding | Except model 454.034 or on vehicles without code (E71) side skirts, BRABUS | |
1.2 | Loosen left and right side skirts, BRABUS in front area until bolts (2) are accessible | On model 454.034 or on vehicles with code (E71) side skirts, BRABUS | |
2 | Remove lower engine compartment paneling | ||
3 | Remove bolts (2) | ||
4 | Remove expansion clip (5) in front area of fender liner. | Installation: Replace damaged expansion clips (5). | |
5 | Unscrew bolt (12) on left and right from front spoiler BRABUS (10) and remove counterholder (11). | On model 454.034 or on vehicles with code (E58) Front spoiler Brabus (DFO) | |
6 | Lower vehicle | ||
7 | Unclip CBS front (1) on left and right side in marked areas (arrows) with clip remover | Carefully unclip CBS front end (1) to prevent damage by breakage or scratching. | |
| |||
8 | Open engine hood | ||
9 | Unscrew bolts (7) in area of engine hood seal (6) | The bolts (7) are shown with engine hood seal (6) removed for better illustration. | |
10 | Unlock retaining clip (4) from hose (3) | On vehicles with code (22Y) Headlamp cleaning system | |
11 | Pull off hose (3) and close opening on washer fluid reservoir with suitable stop plug. | On vehicles with code (22Y) Headlamp cleaning system | |
Collect escaping window washer fluid in suitable container. | |||
12 | Loosen CBS front end (1) and guide forward with aid of helper until electrical connector on left turn signal lamp (E6/1) and right turn signal lamp (E6/2) is accessible. | Treat CBS front (1) carefully to prevent damaging paint | |
Lift CBS front end (1) over guides (8) and lightly pull toward outside in areas of rocker panels. | |||
Installation: Ensure that CBS front end (1) is seated correctly in guides (8, 9). | |||
13 | Disconnect electrical connector from left turn signal lamp (E6/1) and right turn signal lamp (E6/2) | ||
14 | Disconnect electrical connector from left front fog lamp and right front fog lamp | On vehicles with code (V07) front fog lamps (FFO) | |
The left front fog lamp is integrated into the left turn signal lamp (E6/1) and the right front fog lamp is integrated into the right turn signal lamp (E6/2) | |||
15 | Remove CBS front end front end (1) with aid of helper | Carefully remove CBS front end (1) to prevent damage by breakage or scratching. | |
Lightly pull CBS front end (1) toward outside in areas of front rocker panels. Helper required | |||
16 | Install in the reverse order |
Snap-release tool
452 589 01 63 00