ar8880p1050ff

Remove/install side sill protective molding

Typ ar · temat 88.80 · wersja 0102 · 2005-10-12

Dotyczy: MODEL 454.0 (except 454.034) except CODE (E71) Side skirts, BRABUS

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 88 Części dobudowane, klapy zewnętrzne › 88.80 Listwy maskujące — Seria 454 (modele 000, 001, 030, 031, 032, 033)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.38 Zderzak/spojler/okładzina zewnętrzna/schowek/przednie zabezpieczenie › 35.38.42 Okładzina podłużnicy — Seria 454 (modele 000, 001, 030, 031, 032, 033)

AR88.80-P-1050FF

Remove/install side sill protective molding

14.8.03

MODEL 454.0 (except 454.034) except CODE (E71) Side skirts, BRABUS

Remove/install side sill protective molding

P88.80-2122-09

1 Front rocker panel

2 Rear rocker panel

5 Bracket

3 Expansion clip

4 Expansion clip

Remove/install

Danger!

Risk of death caused by vehicle slipping or toppling off of the lifting platform.

Align vehicle between the columns of the lifting platform and position the four support plates at the lifting platform support points specified by the vehicle manufacturer.

AS00.00-Z-0010-01A

1

Raise vehicle

2

Remove expansion clips (4) from front rocker panel (1) or rear rocker panel (2).

Installation: Replace damaged expansion clips (4).

3

Remove expansion clips (3) from front rocker panel (1) or rear rocker panel (2) in area of fender liner.

Installation: Replace damaged expansion clips (3).

4.1

Lightly pull front rocker panel (1) away from vehicle and pull off toward front

When removing front rocker panel (1).

Carefully remove front rocker panel (1) to prevent paint damage

Installation: Position front rocker panel (1) with brackets (5) inserted and press on

5.1

Lightly pull rear rocker panel (2) away from vehicle and pull off toward rear

When removing rear rocker panel (2).

Carefully remove rear rocker panel (2) to prevent paint damage

Installation: Position rear rocker panel (2) with brackets (5) inserted and press on

6

Unscrew bracket (5) from longitudinal member

Installation: Check bracket (5) for damage, replace if necessary.

Insert bracket (5) into front rocker panel (1) or rear rocker panel (2)

7

Install in the reverse order

Powiązane dokumenty