1.1 | Temperature sensor |
1.2 | Temperature limiter |
2 | Electrical connector |
3 | Electrical line |
4 | Retaining bracket |
5 | Screw |
S83.70-4675-06
| Remove/install | ||
1 | Detach stationary heater control unit and swivel out from working area | ||
2 | Disconnect electrical connection (2) | ||
3 | Remove electrical lines (3) from electrical connector (2) | Temperature sensor (1.1), temperature limiter (1.2) and electrical connector (2) form a unit. | |
Installation: Make sure that slots are correctly assigned in electrical connector (2). | |||
Wiring harness repair kit, basic | |||
4 | Remove bolts (5) | ||
5 | Remove retaining bracket (4) | ||
6 | Remove temperature sensor (1.1) and temperature limiter (1.2) | Installation: Replace sealing ring of temperature limiter (1.2). | |
7 | Install in the reverse order | ||
| Check | ||
Danger ! | Risk of explosion caused by fuel vapors igniting, risk of poisoning caused by inhaling combustible gases and risk of injury caused by burns during and after operation of heater unit | Do not operate stationary heater, auxiliary heater or engine with heater booster in closed rooms or when refueling. Allow heater unit to cool down after operation and wear protective gloves. | |
8 | Perform function test of heater |
000 589 13 99 00
Wiring harness repair kit, basic
Powiązane dokumenty
- ar8370s5940e
- as8370z000201a Niebezpieczeństwo wybuchu oparów paliwa, niebezpieczeństwo zatrucia na skutek wdychania spalin i niebezpieczeństwo zranienia na skutek poparzenia podczas lub po fazie grzania.