ar8210p1201d

Remove/install bulbs of headlamp unit

Typ ar · temat 82.10 · wersja 0103 · 2019-12-05

Dotyczy: Model 129 with code 612 (Xenon headlamp unit)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 82 Układ elektryczny, nadwozie › 82.10 Oświetlenie zewnętrzne — Seria 129

EinPAS 30 Instalacja oświetleniowa › 30.15 Oświetlenie zewnętrzne › 30.15.40 Lampa przednia — Seria 129

AR82.10-P-1201D

Remove/install bulbs of headlamp unit

19.11.2019

Model

129

with code 612 (Xenon headlamp unit)

Remove/install bulbs of headlamp unit

1

Housing cover

2

Housing cover

3

Retaining ring

4

Mounting clamp

5

Low beam electrical connection

6

High beam electrical connection

7

Standing light socket

E2e1

High beam

E2e3

Standing lamp

E2e8

Xenon headlamp low beam

P82.10-2130-12

Remove/install

Danger

Risk of death when working on component parts and systems with U >= 30 V alternating voltage (AC) or U >= 60 V direct voltage (DC)

Do not touch damaged or defective live component parts and lines or non-insulated electrical connections and lines.

AS00.00-Z-0035-01A

Danger

Risk of explosion/risk of fire caused by highly flammable materials in the vicinity of damaged xenon bulbs. Risk of injury caused by UV light, hot components on xenon headlamps and glass splinters produced by bursting xenon bulbs. Risk of poisoning caused by inhalation of mercury vapors and by swallowing of/skin contact with toxic salts and mercury compounds.

Do not touch parts conducting high voltage. Persons with active electronic implants (e.g. cardiac pacemakers) must never work on xenon headlamps. Switch off the entire lighting system. Wear insulated safety shoes, safety glasses and protective gloves. Remove highly inflammable materials from the danger zone. Ensure sufficient ventilation in the working area.

AS82.10-Z-0001-01A

1

Switch off ignition

2

Remove windscreen washer fluid reservoir

Only necessary for the right lamp unit.

3

Unclip housing covers (1, 2)

Check seal for damage and wear, replace if necessary.

Code 491 (USA version):

If the xenon bulb is defective, the lamp unit must be replaced

Remove lamp unit


AR82.10-P-4730B

4

Disconnect electrical connection of respective bulb (E2e1, E2e3) or xenon bulb (E2e8)

5

Remove standing light socket (7)

Except CODE 491 (USA version)

6

Open mounting clip (4) or fastening ring (3) of respective bulb

7

Carefully remove bulb (E2e1, E2e3) or xenon bulb (E2e8)

Do not touch the glass of the bulb or xenon bub with your bare fingers, but use a grease-free, soft cloth. Ensure correct installation position.

8

Install in the reverse order

9

Carry out function check

Powiązane dokumenty