AR77.20-P-1700TX | Remove/install tilting bracket on tilting/sliding roof | 12.8.04 |
MODEL 219.3 with CODE (414) Glass electric tilting/sliding roof
P77.20-2498-09
Shown on left pop-up bracket
1 Tilting bracket
2 Water drain channel
3 Long wedge
7 Slide rail
8 Slide block
9 Guide bolts
4 Bracket
5 Screw
6 Slide block
P77.20-2499-07
Shown on left pop-up bracket
1 Tilting bracket
4 Bracket
9 Guide bolts
7 Slide rail
| Remove/Install | ||
1 | Remove tilting/sliding roof panel | ||
2 | Unclip water drain channel (2) from left and right bracket (4) with long wedge (3) and remove | | |
3 | Actuate tilting/sliding roof switch in closing direction until tilting/sliding roof drive switches off | ||
4 | Unscrew bolt (5) from tilting/sliding roof | The cable is disconnected from the pop-up bracket (1) | |
5 | Slide pop-up bracket (1) toward rear with long wedge (3) until the slide block (6) can be lifted out of the slide rail (7) | | |
6 | Lift slide block (6) out of slide rail (7) | ||
7 | Slide pop-up bracket (1) toward front with bracket (4) until the slide block (8) is visible in the opening on the slide rail (7) | ||
8 | Guide slide block (6) over slide rail (7) and route guide bolts (9) along wind deflector guide (arrow) | ||
9 | Pivot bracket (4) upward and remove from pop-up bracket (1) | Carefully pivot bracket (4) otherwise the guide bolts (9) can damage the paint on the vehicle roof | |
10 | Pivot out pop-up bracket (1) parallel to the slide rail (7) (arrow) | ||
11 | Install in the reverse order |
Long wedge
115 589 03 59 00