ar7229d5898ts

Remove, install electric sliding door control unit

Typ ar · temat 72.29 · wersja 0100 · 2018-05-14

Dotyczy: Model 907.6/7

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.29 Instalacja elektryczna drzwi — Seria 907 (modele 6**, 7**)

EinPAS 28 System komfortowy/ wspomagający kierowcę › 28.35 Obsługa komfortowa › 28.35.11 Moduł sterujący/ przekaźnik — Seria 907 (modele 6**, 7**)

AR72.29-D-5898TS

Remove, install electric sliding door control unit

27.04.2018

Model

907.6/7

Remove, install electric sliding door control unit

Shown on right sliding door (2)

1

Sliding door control unit

2

Sliding door

3

Electrical connectors

D72.29-1158-06

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Information on preventing damage to electronic components due to electrostatic discharge

AH54.00-P-0001-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Commission sliding door control unit (1) using vehicle diagnosis system.

If sliding door control unit (1) is replaced.

AD00.00-D-2000-06TS

2

Remove lower door trim from sliding door (2).


Model 907.6/7
except code V4A (Fully lined right load compartment sliding door)

AR72.16-D-6612TS

Model 907.6/7
with code V4A (Fully lined right load compartment sliding door)

AR72.16-D-6612TSB

3

Disconnect electrical connection (3).

4

Unclip sliding door control unit (1) from catch hooks (arrows) and remove.

5

Install in the reverse order.

6

Fully open sliding door (2) using the push button switch for the sliding door (2) and then close again completely.

For normalizing the electric drive of the sliding door (2).

Powiązane dokumenty