ar7220s4055e

Remove/install rear-end door lock

Typ ar · temat 72.20 · wersja 0102 · 2017-11-28

Dotyczy: Model 447.6/7

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.20 Drzwi na ścianie tylnej, drzwi tylne — Seria 447 (modele 6**, 7**)

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.32 Zamek/ klamka — Seria 447 (modele 6**, 7**)

AR72.20-S-4055E

Remove/install rear-end door lock

28.11.2017

Model

447.6/7

Remove/install rear-end door lock

S72.20-4655-09

1

Door lock

5

Bearing bracket

2

Inner lock lock

6

Cable

3

Electrical connector

7

Grommet

4

Inside door opener

8

Screw

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Remove/install

1

Remove inside door opener (4) on rear-end door

Model 447.6/7
with code W50 (Rear-end door, double-wing, 180 degrees without window)
Model 447.6/7
with code W54 (2-wing rear-end door, 270 degrees)

AR72.20-S-4075E

2

Remove door foil from rear-end door

AR72.20-S-4100E

3

Disconnect electrical connector (3)

4

Remove cable (6) from bearing bracket (5)

5

Remove grommet (7)

6

Unscrew bolts (8) and detach door lock (1) on rear-end door

Installation: Ensure that door lock (1) is seated correctly on rear-end door.

7

remove lower inner lock (2) on right

AR72.40-S-4437E

8

Expose right inner upper lock and remove cable

AR72.40-S-4434E

Removal: Do not disconnect electrical connector.

9

Expose all cables on door lock (1) on rear-end door


Do not kink cables on door lock (1).
Otherwise the cables can be damaged and must be replaced.

Observe assembly positions for cables.

10

Guide door lock (1) out of rear-end door and remove


Do not kink cables on door lock (1).
Otherwise the cables can be damaged and must be replaced.

Installation: Ensure that cables are seated correctly on door lock (1).

11

Remove all cables from door lock (1)

When replacing door lock (1).

Observe assembly positions for cables.

12

Install in the reverse order

Check

13

Close rotary tumbler on inner lower lock (2) and inner upper lock with suitable tool

14

Actuate outer door handle and check whether inner lower lock (2) and inner upper lock open and arrest correctly

15

Close rotary tumbler on right inner lower lock (2) and right inner upper lock with suitable tool

16

Actuate inside door opener (4) and check whether inner lower lock (2) and inner upper lock open and arrest correctly

17

Check whether lower inner lock (2) and upper inner lock are seated correctly in the lock striker

If necessary:

Adjust right lower inner lock (2) and upper right inner lock.

Adjust right inner lower lock (2)

AR72.40-S-4437E

Adjust right upper inner lock

AR72.40-S-4434E

Powiązane dokumenty