1 | Inner lock |
2 | Right rear door |
3 | Door lock |
4 | Electrical connector |
5 | Bolts |
6 | Cable |
7 | Rotary tumbler |
S72.20-4657-06
Danger ! | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Open right rear-end door (2) | ||
2 | Remove inner paneling from window frame on right rear-end door (2) | MODEL 447.7 with CODE V23 (Interior trim, luxury equipment) except CODE ZU7 (National version, Canada) and except CODE ZU8 (National version USA), MODEL 447.7 with CODE VK7 (Rear-end door/liftgate paneling, luxury equipment) | |
3 | Mark installation position of inner lock (1) | ||
4 | Loosen door lock (3) on right rear-end door (2) | ||
Detach door lock (3) to remove inner door lock (1). | |||
5 | Expose electrical connector (4) and disconnect | ||
6 | Expose electrical wiring harness for inner door lock (1) on right rear-end door (2) | ||
7 | Remove screws (5) | ||
8 | Pull inner lock (1) upward and remove cable (6) | ||
9 | Guide inner lock (1) with electrical wiring harness upward out of right rear-end door (2) and remove | ||
10 | Remove rotary tumbler switch from inner lock (1) | When replacing rotary tumbler switch or inner lock (1). | |
| Install | ||
11 | Install rotary tumbler on inner lock (1) | If rotary tumbler switch or inner lock (1) is replaced. | |
12 | Insert inner lock (1) with electrical wiring harness into right rear-end door (2) and install cable (6) | ||
13 | Tighten inner lock (1) with screws (5) | Observe markings. | |
14 | Connect electrical connector (4) and fasten electrical wiring harness | ||
15 | Install door lock (3) on right rear-end door (2) | ||
Reinstall door paneling only after checking whether inner lock (1) is seated correctly in lock striker. | |||
16 | Remove inner paneling from window frame on right rear-end door (2) | MODEL 447.7 with CODE V23 (Interior trim, luxury equipment) except CODE ZU7 (National version, Canada) and except CODE ZU8 (National version USA), MODEL 447.7 with CODE VK7 (Rear-end door/liftgate paneling, luxury equipment) | |
| Check | ||
17 | Close rotary tumbler (7) on inner lock (1) with suitable tool | ||
18 | Actuate outer door handle or inside door handle and ensure that inner lock (1) opens and arrests correctly | ||
19 | Check whether inner lock (1) is seated correctly in lock striker and tighten screws (5) | If it is necessary to correct the seat of the inner lock (1) in the lock striker: | |
| |||
Adjust inner lock (1) in relation to lock striker. | |||
Bolt, inner lock to rear-end door |
Powiązane dokumenty
- ar7220s4055e
- ar7220s6630e
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.