Remove/install inner lock of right bottom rear-end door

AR72.40-S-4437E

Remove/install inner lock of right bottom rear-end door

17.7.15

Model

447.6/7

Shown on model 447.6 with code W50 (Two-wing rear-end door, 180 degrees without window)

1

Inner lock

2

Right rear door

3

Bolts

4

Cable

5

Rotary tumbler

 Danger !

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A



Remove

1

Remove cover from rear-end door trim (2)

Model 447.7
with code V23 (Interior panelling higher execution)
except code ZU7 (National version for Canada)
except code ZU8 (National version for USA)

AR72.20-S-6615-01E

2

Mark installation position of inner lock (1)

3

Remove bolts (3)

4

Remove cable (4) from inner lock (1)



Install

5

Install cable (4) on inner lock (1)

6

Tighten inner lock (1) with bolts (3)

 Observe markings.



Check

7

Close rotary tumbler (5) on inner lock (1) with suitable tool

8

Actuate outer door handle or inside door handle and ensure that inner lock (1) opens and arrests correctly

9

Check whether inner lock (1) is seated correctly in lock striker and tighten bolts (3)

If it is necessary to correct the seat of the inner lock (1) in the lock striker:



Adjust inner lock (1) in relation to lock striker.

 Bolt, inner lock to rear-end door

*BA72.20-N-1012-01J



Install

10

Install cover on rear-end door trim (2)

Model 447.7
with code V23 (Interior panelling higher execution)
except code ZU7 (National version for Canada)
except code ZU8 (National version for USA)

AR72.20-S-6615-01E

 Rear-end door

Number

Designation

Model 447.6/7
with code W54 (2-wing rear-end door, 270 degrees)

Model 447.6/7
with code W50 (Rear-end door, double-wing, 180 degrees without window)

BA72.20-N-1012-01J

Bolt, inner lock to rear-end door

Nm

8

8