ar7220s2650e

Remove/install rear-end door hinge

Typ ar · temat 72.20 · wersja 0100 · 2014-06-11

Dotyczy: MODEL 447.6/7 with CODE W50 (Rear-end door, double-wing, 180 degrees without window) MODEL 447.6/7 with CODE W54 (Hinged rear doors, opening to side wall)

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.20 Drzwi na ścianie tylnej, drzwi tylne — Seria 447 (modele 6**, 7**)

EinPAS 35 Karoseria/ rama/ elementy domontowane › 35.35 Drzwi › 35.35.43 Drzwi tylne — Seria 447 (modele 6**, 7**)

AR72.20-S-2650E

Remove/install rear-end door hinge

23.05.2014

MODEL	447.6/7
	with CODE W50 (Rear-end door, double-wing, 180 degrees without window)
MODEL	447.6/7
	with CODE W54 (Hinged rear doors, opening to side wall)

Remove/install rear-end door hinge

S72.20-4653-09

Shown on right rear-end door (5)

1	Top hinge		8	Screw
2	Bottom hinge		9	Screw
3	Cover		10	Bolts
4	Trim piece		11	Bolts
5	Rear-end door		12	Screw
6	Bodywork		13	Bolts
7	Bolts		14	Screw

 Danger !	Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.	No parts of the body or limbs should be within the operating area when the components are moving.	AS00.00-Z-0011-01A
	Removing and installing upper hinge (1)
1	Remove corresponding trim piece (4)		AR88.85-S-5474E
		 Installation: Install trim piece (4) only after adjusting upper hinge (1).
2	Mark installation position of upper hinge (1) on body (6) and rear-end door (5)
3	Unscrew screws/bolts (7, 10)
4	Secure corresponding rear-end door (5) against falling down	 Helper required.
5	Unscrew bolts (8, 9) and remove upper hinge (1)	 Installation: Observe marking.
6	Install top hinge (1) in reverse order
	Removing and installing lower hinge (2)
7	Remove corresponding paneling (3)	 Installation: Install paneling (3) only after adjusting lower hinge (2).
8	Mark installation position of lower hinge (2) on body (6) and rear-end door (5)
9	Secure corresponding rear-end door (5) against falling down	 Helper required.
10	Unscrew screws/bolts (11, 13)
11	Unscrew bolts (12, 14) and remove lower hinge (2)	 Installation: Observe marking.
12	Install bottom hinge (2) in reverse order
	Adjust
13	Adjust upper hinge (1) and lower hinge (2)		AR72.20-S-1032E

Powiązane dokumenty

ar7220s1032e
ar8885s5474e
as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.