ar7220d0101ts

Remove/install lower rotary tumbler on rear-end door

Typ ar · temat 72.20 · wersja 0100 · 2018-05-16

Dotyczy: Model 907.6/7, 910.6

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 72 Drzwi › 72.20 Drzwi na ścianie tylnej, drzwi tylne — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

EinPAS 29 System uprawniający do jazdy/zabezpieczający › 29.16 Blokowanie/ odblokowanie › 29.16.32 Zamek/ klamka — Seria 907 (modele 6**, 7**) · Seria 910 (modele 6**)

AR72.20-D-0101TS

Remove/install lower rotary tumbler on rear-end door

16.03.2018

Model

907.6/7, 910.6

Remove/install lower rotary tumbler on rear-end door

D72.20-1259-09

1

Bolts

3

Bottom rotary tumbler

2

Rear-end door

4

Cable

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Topical note

Notes on carrying out repair work in the vehicle interior

AH68.00-N-0001-01S

Remove/install

1

Remove bottom door trim of the left rear-end door (2).

Model 907.6/7 with code VA1 (load compartment trim up to standard belt rail) or with code VA5 (hinged rear doors full trim), model 907.6, 910.6 with code VA2 (load compartment interior trim up to roof height (wood)) or with code VA3 (load compartment interior trim up to roof height, can be washed)

Model 907.6/7
with code VA5 (Fully lined hinged rear doors)

AR72.20-D-6615TS

Model 907.6/7 with code VA1 (Load compartment trim up to belt rail standard), model 907.6, 910.6 with code VA2 (Load compartment interior trim up to roof height (wood)) or with code VA3 (Load compartment interior trim up to roof height, can be washed)

AR72.20-D-6619TS

2

Mark position of screws (1) on inner door panel of rear-end door (2).

3

Unscrew screw/bolts (1).

Installation: Pay attention to installation markings.

Screw, rotary tumbler to bottom of rear-end door

*BA72.20-N-1002-01TS

4

Remove bottom rotary tumbler (3) from rear-end door (2) until the cable (4) is accessible.

5

Remove cable (4) from bottom rotary tumbler (3) and remove bottom rotary tumbler (3).

6

Install in the reverse order.

Check

7

Carry out function check of the bottom rotary tumbler (3).

8

Check whether the bottom rotary tumbler (3) and the top rotary tumbler open simultaneously when the left rear-end door is opened.

If the bottom rotary tumbler (3) and the top rotary tumbler do not open simultaneously,

Adjust the bearing bracket.


AR72.20-D-4014-01TS

Rear-end door

Number

Designation

Model 907.6/7, 910.6

BA72.20-N-1002-01TS

Screw, rotary tumbler to bottom of rear-end door

Nm

10

Powiązane dokumenty