Shown on left door lock (5) with code FZ8 (Comfort opening and closing with IR remote control) |
1 | Electrical connector |
2 | Electrical wiring harness |
3 | Cable |
4 | Bearing bracket |
5 | Door lock |
6 | Cable |
7 | Actuator rod |
S72.10-4606-06
| Remove | ||
1 | Detach door module together with door lock (5) and bearing bracket (4) from front door | ||
Do not disconnect electrical connectors at front of door module. | |||
Secure door module against falling down. | |||
2 | Disconnect electrical connector (1) from door lock (5) | ||
3 | Remove electrical connector (2) from door module (5) | Model 447, 448 | |
4 | Remove cable (3) from door lock (5) and remove door lock (5) together with bearing bracket (4) from door module | ||
5 | Release catch hook (arrow A) and remove bearing bracket (4) in the direction of the arrow from door lock (5) | ||
6 | Remove cable (6) from bearing bracket (4) | ||
7 | Remove actuator rod (7) from door lock (5) | When removing door lock (5) on driver's side. | |
| Install | ||
8 | Install actuator rod (7) on door lock (5) | When installing door lock (5) on driver's side. | |
9 | Install cable (6) on bearing bracket (4) | ||
10 | Slide bearing bracket (4) onto guide of door lock (5) until catch hook (arrow A) engages | ||
11 | Install cable (3) on door lock (5) | ||
12 | Fasten electrical wiring harness (2) on door lock (5) | Model 447, 448 | |
13 | Connect electrical connector (1) to door lock (5) | ||
14 | Position and tighten door lock (5) together with bearing bracket (4) in front door | ||
Secure door module against falling down. | |||
15 | Install outer door handle in front door | ||
| Check | ||
16 | Check function of door lock (5), bearing bracket (4) and outside door handle | If malfunction is present | |
| |||
Check that mounting and connection components are correctly seated. | |||
| Install | ||
17 | Install door module | ||
| Check | ||
18 | Perform function check of closing and locking system |