Shown on model 257.### 1# |
1.1 | Front passenger door hinge leaf |
2 | Bolts |
P72.10-4608-03
Shown on model 257.### 1# |
1.2 | A-pillar hinge leaf |
P72.10-4610-03
Shown on model 257.### 1# |
3 | Nuts |
F1/3 | Passenger-side A-pillar fuse box |
P72.10-4609-06
Warning | Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof. | No parts of the body or limbs should be within the operating area when the components are moving. | |
| Remove | ||
1 | Remove front passenger door. | ||
2 | Mark installation position of front passenger door hinge leaf (1.1) and A-pillar hinge leaf (1.2). | ||
3 | Remove door sill trim | ||
4.1 | Unclip front passenger side A-pillar fuse box (F1/3) from A-pillar (arrows) and set aside. | Model 257.### 1# , 290.### 1# | |
Do not disconnect electrical lines. | |||
4.2 | Remove lower insulation insert. | Model 257.### 2# , 290.### 2# | |
The bottom insulation insert is inserted into the A-pillar before the nuts (3). | |||
5 | Unscrew nuts (3), release A-pillar hinge leaf (1.2) and remove. | Long wedge | |
6 | Remove seal under A-pillar hinge leaf (1.2). | ||
7 | Clean A-pillar in area of hinge support. | Cleaner | |
8 | Remove screws (2) and remove front passenger door hinge leaf (1.1). | ||
| Install | ||
9 | Align front passenger door hinge leaf (1.1) by means of the previously applied markings on front passenger door and tighten screws (2). | Screw/bolt, hinge to front door | |
10 | Align A-pillar hinge leaf (1.2) with seal on A-pillar by means of the previously applied markings and tighten nuts (3). | Helper required for exact positioning and holding of A-pillar hinge leaf (1.2). | |
Nut, hinge to A-pillar | |||
11 | Install front passenger door. | ||
12 | Open and close front passenger door. | The installation position of the passenger door may change later due to opening and closing. | |
| Check | ||
13 | Check gap dimensions at front passenger door, adjust if necessary. | ||
| Install | ||
14 | Repair paint damage at respective bolt heads. | ||
15 | Protect front passenger door and A-pillar in the area of hinge against corrosion. | Wax for engine compartment (400 ml spray can) | |
16.1 | Clip front passenger side A-pillar fuse box (F1/3) into A-pillar. | Model 257.### 1# , 290.### 1# | |
16.2 | Install lower insulation insert. | Model 257.### 2# , 290.### 2# | |
17 | Install door sill trim. |
115 589 03 59 00
Long wedge
Powiązane dokumenty
- ar7210p0500fr
- ar7210p0552fr
- as0000z001101a Niebezpieczeństwo zranienia przez zakleszczenie lub zmiażdżenie palców podczas demontażu, montażu i prac regulacyjnych przy pokrywach, drzwiach i oknie dachowym.