ar6830p1185frx

Remove/install side load compartment paneling

Typ ar · temat 68.30 · wersja 0100 · 2019-02-22

Dotyczy: Model 290

Niedostępne w języku „pl”; wyświetlono w języku Angielski.

Umiejscowienie

Grupa funkcyjna 3 Nadwozie › 68 Wyposażenie wewnętrzne › 68.30 Wykładziny, rama ozdobna — Seria 290

EinPAS 37 Wyposażenie wnętrza › 37.45 Okładzina › 37.45.35 Okładzina przestrzeni ładunkowej — Seria 290

AR68.30-P-1185FRX

Remove/install side load compartment paneling

11.07.2018

Model

290

Remove/install side load compartment paneling

P68.30-4079-07

Shown on right side of vehicle

1

Cargo area paneling

2

Mounting clip

Warning

Risk of injury caused by fingers being jammed or pinched when removing, installing or aligning hoods, doors, trunk lid/rear-end door or sliding roof.

No parts of the body or limbs should be within the operating area when the components are moving.

AS00.00-Z-0011-01A

Notes on HANDS-FREE ACCESS

AH80.61-P-0001-01A

Remove/install

1

Remove top side load compartment trim.

AR68.30-P-1186FRX

Do not remove seat belt end fitting.

2

Remove upper rear-end center-section trim.

AR68.30-P-4787FRX

3

Remove load compartment floor front section.

AR68.80-P-0010FRX

4

Remove retaining clip (2).

5

Unclip load compartment trim (1) from the rear to the front from retaining clips (arrows) and remove until electrical connectors can be accessed.

Installation: Ensure that sealing frame is seated correctly on liftgate.

6

Disconnect electrical connector at load compartment trim (1).

The number of electrical connectors can vary depending on the vehicle equipment.

7

Remove load compartment trim (1).

8

Install in the reverse order.

Powiązane dokumenty