Separate corner pillar paneling outer bottom section

AR64.30-D-5705-05TS

Separate corner pillar paneling outer bottom section

 Caution

Risk of injury caused by scraping or cutting body parts on sharp vehicle parts

Always wear protective gloves when working on or near sharp and non-deburred vehicle parts.
Deburr repair panels.

AS00.00-Z-0017-01A

Model

907.6/7, 910.6

Repair materials

Number

Designation

Order number

BR00.45-Z-1056-07A

1K-zinc dust paint

A 000 986 28 00

1

Expose weld seam and separating points on corner pillar paneling lower section (1) (areas A, C and C1).

2

Scribe separation lines on corner pillar paneling lower section (1) (areas A, C and C1).

3

Cut corner pillar paneling lower section (1) at separating points (areas A, C and C1).

a

Dimension (approx. 100 mm)

b

Dimension (approx. 15 mm)

4

Expose spot welds on corner pillar paneling lower section (1) (areas D, E, E1, F, F1, F2, G and H).

5

Cut off spot welds on corner pillar paneling lower section (1) (areas D, E, E1, F, F1, F2, G and H).

 Cut off spot welds through 2 panel thicknesses (areas E1, F2 ).

 Cut off spot welds on underside of spot weld flange (area F).

 Cut off spot welds on upper side of spot weld flange (area F2).

6

Expose weld seam on corner pillar paneling lower section (1) (area I).

7

Cut weld seam at corner pillar paneling lower section (1) (area I).

8

Remove damaged corner pillar paneling lower section (1).

9

Sand down mating surfaces to bare metal in cross-hatched areas .

 Sand down spot weld flanges to bare metal on both sides.

10

Grind cross-hatched areas around holes down to bare metal (areas U, U1).

11

Remove shavings and milling chips.

12

Zinc dust paint to insides of spot weld flanges.