The following steps are shown on the left side of the vehicle and must be accomplished analogously on the right side in the event of damage.
P63.50-4054-08
1 | Mark separating point on fender (1) according to picture and cut (area A). |
Do not make the cuts too deep. |
Dimension:a = 54 mm |
2 | Expose weld seams on fender (1) and cut (areas B, C). |
P63.50-4057-04
P63.50-4055-08
3 | Heat flow drill bolts on fender (1) and unscrew (area E). |
Flow drill bolts are glued. |
4 | Expose self-piercing riveting on fender (1) and cut (areas D, F). |
P63.50-4056-08
5 | Expose self-piercing riveting on fender (1) and cut (area G). |
P63.50-4058-08
6 | Expose self-piercing riveting on fender (1) and cut (area H). |
P63.50-4059-08
7 | Expose self-piercing riveting on fender (1) and cut (areas I, J, L). |
P63.50-4060-08
8 | Expose self-piercing riveting on fender (1) and cut (area K). |
P63.50-4061-09
9 | Heat fender (1) in crosshatched areas and remove. |
Cross-hatched areas are bonded. |
10 | Grind mating surfaces down to bare metal in the cross-hatched inner C-pillar sidewall . |
Observe pretreatment of bonding surfaces. |
11 | Remove shavings. |
P63.50-4062-06